
Special Emulsion

Description
Tower Special Emulsion is superior quality paint. It is specially formulated. It has excellent application properties and a smooth pleasing finish. It can be applied on interior walls, ceiling, old new concrete plaster, chipboard and hard board.
Usage
Tower Special Emulsion is used for all normal interior masonry surfaces including brickwork, plaster, cement and wallboard.
Surface Preparation
New, bare, old or previously painted surfaces must be clean, dry and free from dust or wax. Clean the surface by rubbing down with abrasive paper. Brush down previously painted surface completely and make the surface smooth. For large holes and cracks, use plaster of Paris or white cement .Allow to dry. Apply Tower Wall Sealer in order to seal the surface from water and salts. Allow surface to dry completely. Then apply Tower Wall Filling and allow it to dry. Rub down the surface with abrasive paper and dust off. Now the surface will be smooth and ready for Tower Special Emulsion to be applied. Stir the paint thoroughly before use.
Application
NO OF COATS:
Two or Three
COMPOSITION:
PVA Based Emulsion
MIXING RATIO:
Single pack, ready to use after 50% thinning with water.
DRYING TIMES:
Its Depend on temperature, humidity, air movements and film thickness
Surface dry:
2 – 3 Hours
Recoat able:
5 – 6 Hours
APPLICATION :
Brush, Roller or conventional spray.
THINNER :
Water
FILM THICKNESS:
Wet:75 – 100 Micrometers Dry :30 – 44 Micrometers