
Matt Finish

Description
It is formulated to protect Walls, Iron, and Wood which are under extreme conditions in a matt look.
Surface Preparation
New Or Bear Masonry Surface:
Remove all dirt and grease etc by wiping with suitable solvent. Remove all the rust by scraping, chipping and wire brushing. Prime with Tower Primer and allow it to dry for 24 hrs
Previously Painted Surface:
Clean the surface by removing all dirt and grease. Remove loosely adhering or defective paint. For best results apply one coat of Tower primer sealer .It will give excellent finish and smooth silky effect.
Wood Surface
Ensure wood is moisture free. Dry scuff with sand paper. Apply one coat of Tower under coat and allow it to dry over night. Dry scuff again fill the surface if required and dry scuff once more.
Application
NO OF COATS:
2
COMPOSITION:
Based on Alkyd Resion
MIXING RATIO:
Single pack, ready to use after 50% thinning with water.
DRYING TIMES:
Depends on temperature, humidity, air movements & film thickness
Touch dry:
2-3 Hours
Recoat able:
8-12 Hours
Hard dry:
24 Hours
APPLICATION :
Brush, Roller or conventional spray.
THINNER :
Solvent
FILM THICKNESS:
20-25 microns per coat.