
Silk Emulsion

Description
No-1 National Silk Emulsion is an economical emulsion with improved hiding power and a smooth finish. It is suitable for all normal interior masonry surface including brick work, plaster, cement and wall boards
Surface Preparation
Surface must be clean, dry and free from efflorescent salts, after priming with No 1 National Prime-on, fill surface with a mixture of 4 parts chalk, 1 part lithopone and 3-4 parts No 1 National Prime-on on to give it paste like consistency. Allow to dry overnight.
Remove all defective or poorly adhering material by rubbing down using a suitable abrasive paper and dust off. Spot prime and fill surface as described abouve is required.
Make good minor defects. For large holes and cracks use sand and cement mixture. Allow to dry. Prime surface and then fill any surface imperfections with the filler described abouve. Allw to dry over night scuff surface using abrasive paper and dust off.
Application
NO OF COATS:
Two or Three
COMPOSITION:
PVA Based Emulsion
MIXING RATIO:
Single pack, ready to use after 50% thinning with water.
DRYING TIMES:
Its Depend on temperature, humidity, air movements and film thickness
Surface dry:
2 – 3 Hours
Recoat able:
5 – 6 Hours
APPLICATION :
Brush, Roller or conventional spray.
THINNER :
Water
FILM THICKNESS:
Wet:75 – 100 Micrometers Dry :30 – 44 Micrometers